In order to receive
CCN programming the receivers must
be programmed to receive the CCN
channel. Your installer should have
set this up during the installation
process.
You can verify that your receiver is working by tuning your ADTH receiver to the CCN channel. If your system is properly set up you will see a CCN logo animation and hear music. If you are unable to see the CCN logo, please follow the instructions below.
Programming Channel
reception:
Keystrokes
Screen
Displays
Press “Menu” Button
on remote control
Main
Menu
Usingandbuttons,
highlight Installation
and then press “OK” button
Installation
Menu
Usingandbuttons,
highlight “Service
Searching” and
then press “OK” button
Service
Searching Menu
Usingandbuttons,
highlight “Manual
Searching” and
then press “OK” button
Manual
Searching
Do
not change any of
the settings on this
screen. Press
the “OK” button.
APPEND? Yes No
Use
the button
and highlight “Yes” then
press “OK”
Saving
Data Please wait
Press
the “Menu” key
three times to exit from
menus
Different stations will show up on different receivers on Channel
1.
Press
thebutton until the CCN identifier appears
CCN
Animated Logo
Congratulations!
You are now set up to receive
CCN.
If you do not find the station with the CCN rotating logo and music, call our tech support at 1-800-321-6781 for assistance.
If you get a display
on the CCN Channel that indicates “e16
the service is currently scrambled”, please
call 1-800-321-6781 for authorization.
Copyright 2005 Church Communication Network Inc. All Rights Reserved
and
buttons,
highlight Installation
and then press “OK” button 
button
and highlight “Yes” then
press “OK”